In most cases, depending on what model, the VIN for a go kart can be found on the frame of either the driver or passenger side. Do go karts have VIN numbers?Įach go-kart has a black serial number on a white label located on the floor pan immediately in front of the driver’s seat. During their long production run, Carter go-karts were some of the best known and most popular American-made ‘karts. How do I identify my Manco go kart?Ĭarter Brothers made high quality go-karts from 1967 until a fire destroyed their facilities in 2010. Completely restored top speed of 40 mph with good torque. Does Manco still make go karts? – Related Questions Is Carter Brothers Go Karts still in business? How fast is a Manco go kart? In 1997, the company announced that it would be acquired by Germany’s Henkel KGaA, a diversified manufacturer with $10 billion in annual sales. filed for voluntary Chapter 11 bankruptcy in March 2002. Less than a 1/4 inch in most cases.Who bought Manco? Manco Products, Inc. (Note-You should not have to move the motor very much at all. Have someone help you pull the engine forward ever so slightly until there is approximately a 1/8 inch clearance between the inside of the belt and the driver clutch sheave. Drape the belt over the open driver clutch pulley and then pull the belt tightly to the rear and straight back (the belt should still be over the exposed sheave (a short cylinder that protrudes from the driver clutch) on the face of the driver clutch. Make sure that the engine is straight and that the torque converter pulley are perfectly aligned. Step 7 - Align the Engine and Torque Converter Pulleys Remove the belt from the torque converter. It should look almost identical to the very first piece that you removed (except it will be facing in the reverse position). There will be another Frisbee looking drum face you will need to remove. Remove it as well Step 4 – Remove the Drum Rear Face There will be a hexagonal peg that you can remove with a 3/16 inch hex key. Step 3 – Remove the Shoe Driver Assemblyĭirectly behind the drum of the pulley, there should be a small circular device with a spring wrapped around it. The drum should resemble a small circular Frisbee.
Step 2 – Remove the Outer Driver Clutch Pulley Drum FaceĪfter you have removed the bolt from the center of the driver pulley, carefully remove the drum from the outer face of the pulley. There may be a couple of washers that you will need to remove as well. Using the screwdriver or hexagonal tool (varies from model to model), remove the bolt from the center of the driver pulley. In most cases, the driver clutch pulley will be the smaller of the two. In a go kart torque converter, there are two pulleys: the driver clutch pulley and the driven pulley. Step 1 – Remove Driver Clutch Pulley Main Boltįirst, you will need to identify the driver pulley of the torque converter.
0 kommentar(er)
